Free Seo Webmaster Tools + Free Article Submissions | Adjustment and maintenance of CNC lathes

Machine tool Debugging Tools in place, the customer designated location, location, put away up now. Mattress pad will be a good machine, machine tools wipe clean, and adjust the level. To the machine hydraulic tank, oil tank, filling the corresponding label and the fuel rail lubricant to the cutting machine tool coolant tank plus good. Rated power consumption by machine, installed the appropriate power, and to install a good regulator and machine ground. Adjusted the machine spindle rotating, and check the switch button and the machine is functioning.

Caution Machine operator must be qualified through formal training and personnel, machine operators use machines, be sure to see familiar machine operating instructions and understand the contents before operating the machine tool. Check whether the electric doors are closed, lubricating oil, coolant is sufficient, in and around machine tools should not be a foreign body, preventing the machine's movement. Before operating the machine tool, carefully check the data entered to ensure that the specified feed rate and want to adapt to the machine operation, if the use of incorrect data, or not in the correct speed of operation, machine malfunction may occur, causing damage to the workpiece or the machine itself or causing damage. Machining before, we must first check the normal operation of machine tools in the machine tool is not installed when the workpiece and the machine tools and the right to run. When using the tool compensation function, please double-check the direction and compensation for the amount of compensation, using the incorrect data manipulation tools, machines may malfunction, which may cause the workpiece or the machine itself or causing damage. When the manual machine, you should confirm the current position of tool and the workpiece and to ensure that you correctly specify the axis of motion, direction and feed rate. Hand wheel feed rate when the next rotation in a large hand wheel, tools and platforms will be fast moving, could have hand-wheel to stop turning, the cutting tool and the table will not stop the phenomenon. Large magnification of the hand wheel movement may cause damage to the machine tool or even cause injury to persons. If fault can not be excluded machine, please machine vendor.

Machine maintenance

Always check the adequacy of oil, pipeline or without plug, lubricant and coolant pollution level, the need to change. Turret moves freely, installation and removal tool if there is interference, whether the injury tip; Tailstock taper hole have dirt, cone for damage. Regular inspection X, Z 2-axis motion is smooth, regular cleaning X, Z of the trip switch, so that there is water and dust, affecting. Appearance of regularly cleaning the machine, such as control panel, system monitor; regularly check electrical outlet into the cabinet and electrical cabinet office have dust, there is the rub. Strong electrical cabinet electrical periodic inspection plate, servo units, spindle cells have dust, there is in case of power failure or a vacuum cleaner with a brush. Check regularly check whether the rotating fan shaft, whether debris, there is clear, so as not to affect the spindle running. Regular inspection checks on the strong electric drive relay is normal, necessary, replace. If the system displays the battery alarm, should promptly contact with the machine tool manufacturers, the timely replacement. Troubleshooting.